Extruded Aluminum furniture is formed by forcing aluminum stock through dies. The result is a seamless extrusion of aluminum that comes in may shapes and forms. It can be bent into beautiful shapes and styles. The frames are then welded and finished with a durable powder coating process. This finishing process for aluminum, iron and steel grinds a plastic coating into fine talc and is blown on to a chemically cleaned and etched surface of the metal. When baked, the talc melts and fuses into the metal producing a thick durable weather resistant coating which is substantially thicker than a normal spray paint process. This state of the art process is warranted by manufacturers against peeling and flaking due to defective painting.
A spray nozzle and a garden hose is your best defense. Periodic cleaning of frames is recommended. Simply wash with mild soap and rinse thoroughly. Do not use any kind of wax, abrasive materials or strong detergents on textured finishes.
REPAIRING SCRATCHES & SCRAPES IN FINISH
Touch-up paint to match your frame color is available at Casual Marketplace or from your manufacturer. Place the frame in an open area with plenty of ventilation – preferable outdoors. Using a very fine grit sand paper (120 grit or more) lightly sand the damaged area until smooth with the rest of the surface. Using a clean rag lightly dipped in rubbing alcohol or mineral spirits, wipe the sanded area clean of dirt and oil. This primes the affected area and provides the maximum bonding surface for the paint to adhere. Shake spray can for at least one minute. Holding the spray can 8 – 10 inches away from surface to be touched up, spray the damaged area lightly in an even left to right motion. This action helps to prevent paint runs. For best results, make two to three light coats allowing paint to dry in between coats. Read the information affixed to the spray can for additional information. Touch up applications should be limited to as small an area as necessary to repair the damage. Be sure to use the left to right motion when touching up to feather the area into the established finish area. Wait until paint is very dry before determining if an additional coat is needed. Small nicks – spray touch-up paint onto a flat plate or dish. Use a small artist’s brush to transfer the paint from the plate to the furniture. Texture can be enhanced with a clean dry brush after the paint becomes sticky.